P1361 honda civic 2002

The car almost stalled yesterday and check engine light came on. I pulled up the code: P Checked the sensor connection and everything looked fine.

Troubleshooting a P code Thread Tools. Hey everyone! Although I'm not opposed to replacing it, I was hoping to get a little help in troubleshooting it to make sure that it's not a wiring issue I've gotten CEL codes on two different occasions.

P1361 honda civic 2002

Engine Post your engine related problems in this section. Engines will cover from Fuel, Engine, Cooling, Exhaust physical related items. P Code, Engine Runs with half the power. Thread Tools. I have a Honda Civic and about a week ago the car shut off and the engine light came on. I turned on the car and it performed at half the power as before. I waited for about 20 minutes and drove the car again and the car worked fine then the problem occurred again. I took it to the dealership and diagnosed it and the code that came up was P The dealer told me i had to replace the cylinder heads but i am not sure if that is the problem. Should i replace the TDC Sensor first? View Public Profile.

Just got a diagnosis from Honda and found out that there is excessive camshaft play and the entire head needs to be replaced P Code, Engine Runs with half the power. About LinkBacks.

.

At Fixya. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated. When trafic is heavy check light turns on. The motor stops and have to restart. The cicle continues.

P1361 honda civic 2002

What does the P code Honda Civic mean? The code can occur due to a bad sensor, open or shorter wire, and a poor electric connection. When you experience this problem, your vehicle stops working and requires repair immediately.

Nude asmr

One thing I did forget about was re-learning engine idle. Checked the sensor connection and everything looked fine. From there i drove to a place that could check my check engine light code. Pulled on side of road for 5 mins, started back up and made to location i was going to. View Public Profile. I took it to the dealership and diagnosed it and the code that came up was P Find More Posts by gearbox. I disconnected the battery beforehand and when I reconnected I got in and drove right away. NO - Intermittent failure, system is OK at this time. Is there continuity? Disconnect the CMP 3-pin connector.

It is caused by excessive end play in the camshaft of your vehicle.

YES - Go to step 9. View Public Profile. I drove it straight to a garage to get looked at. Troubleshooting a P code Is there continuity? LinkBack URL. Car went into limp mode, CEL came on and was stalling a lot and running really hot. My question is -- should I just act like the light is on -- and follow the prompts from there? Find More Posts by dxtn. I forget where I read it but someone mentioned just loosening the valve cover bolts and prying up on the rights side to remove the upper timing belt cover instead of completely removing the valve cover. Purchased the sensor and had the old one out and the new one in less than an hour later with nothing more than a ratchet, 3" extension, 10mm deep and short socket and a flathead screwdriver. Hv a honda civic hx and got a reading P, the car turns over but wont star. Turn the ignition switch Off. Swap the existing CMP sensor with one that is known-good, then recheck.