Garmin fenix 3 battery replacement

Your message was sent. You will receive a confirmation email soon.

This guide will give you step-by-step instructions on how to quickly swap out that old battery for a new one. Use a plastic opening tool to remove the face of the device to expose the inner components. There is one metal piece at the top of the face that is loose. This is the GPS antenna which will need to be removed as well. Another ribbon is attached to the top of the motherboard. Disconnect this ribbon. The battery is glued to the motherboard and will need pried off using the nylon spudger.

Garmin fenix 3 battery replacement

If the battery is not holding a charge as long as it should, or is failing to charge at all, use this guide to replace the battery. You will need a T6 Torx screwdriver, a T5 Torx screwdriver, and a spudger. Do not yank the face. A ribbon connector connects the face and the motherboard, and yanking could result in damage to the motherboard or ribbon. Use a spudger to lift up and free the screen ribbon cable's press-fit connector from the motherboard. Use a T5 screwdriver to remove the two silver 1. To avoid losing or dropping the screws once they are loose, use tweezers to extract them. Lift the watch and turn it over one hand. The motherboard should fall out easily. When reinserting your motherboard, slide it in instead of pressing it.

After a good clean with meths and a cotton bud I popped the original battery back in, reassembled it, and hey presto! To avoid losing or dropping the screws once they are loose, use tweezers to extract them. It installed without difficulty, it took me 10 minutes to disassemble and reassemble.

.

This guide will give you step-by-step instructions on how to quickly swap out that old battery for a new one. Use a plastic opening tool to remove the face of the device to expose the inner components. There is one metal piece at the top of the face that is loose. This is the GPS antenna which will need to be removed as well. Another ribbon is attached to the top of the motherboard. Disconnect this ribbon. The battery is glued to the motherboard and will need pried off using the nylon spudger. Cancel: I did not complete this guide. Badges:

Garmin fenix 3 battery replacement

And it was necessary to change it because, at first, the battery started to serve for a short time, but later, the watch stopped charging. Therefore, I decided to order a new battery and try to change it myself. And what can I say? I also decided to find a list of Garmin watch models that require battery replacement.

The descent imdb

Use a T5 screwdriver to remove the two silver 1. Replaces the following products Garmin When reinserting your motherboard, slide it in instead of pressing it. Your message was sent. Specialist Batteries. Almost done! What you need. Fix Your Stuff Community Store. The new battery has the same dimensions, only the adhesive strip was missing. Original language: italian. Using the spludger, separate the battery from the motherboard, which are both held together with a mild adhesive. Step 4. The trademark names and trademarks cited on our web pages serve exclusively serve to provide information about our products.

If the battery is not holding a charge as long as it should, or is failing to charge at all, use this guide to replace the battery. You will need a T6 Torx screwdriver, a T5 Torx screwdriver, and a spudger. Do not yank the face.

In order to give you a better service subtel uses cookies. You're Finished! The motherboard must go beneath a lip at the base of the watch body. Order status Email. Replaces the following products Garmin Very happy! Look closely to make sure no part of the connector is sticking up, even a hair or it will not work. Universal Cables. Step 7 Battery. Another ribbon is attached to the top of the motherboard.